2 layer board of 0.99 x 0.87 inches (25.0 x 22.0 mm)
Uploaded:
April 18th 2018
Shared:
April 18th 2018
Total Price:
$4.25
Simple(st) and cheap(est) interface for Davis Vantage Vue with v3 software (infamous green dot). Tested with Vantage Vue, should work with other stations too.
IC1 = ATTiny85 with program from : http://meteo.annoyingdesigns.com/DavisSPI.pdf
C1 = 100n (optional)
D1 = 3v3 Zener (optional)
…
Simple(st) and cheap(est) interface for Davis Vantage Vue with v3 software (infamous green dot). Tested with Vantage Vue, should work with other stations too.
IC1 = ATTiny85 with program from : http://meteo.annoyingdesigns.com/DavisSPI.pdf
C1 = 100n (optional)
D1 = 3v3 Zener (optional)
R1 = 470R (optional, short if not used)
J1 = 2x10 female header 2.0mm pitch
Should be used with USB-UART cable (tested with PL2303, should work with others too), B-ground, W-cable’s Tx, G-cable’s Rx. If cable is 5V one, it’s recomended to use R1 and D1 as a voltage clamping since Davis operates at 3v3.
Show full description
Simple(st) and cheap(est) interface for Davis Vantage Vue with v3 software (infamous green dot). Tested with Vantage Vue, should work with other stations too.
IC1 = ATTiny85 with program from : http://meteo.annoyingdesigns.com/DavisSPI.pdf
C1 = 100n (optional)
D1 = 3v3 Zener (optional)
…
Simple(st) and cheap(est) interface for Davis Vantage Vue with v3 software (infamous green dot). Tested with Vantage Vue, should work with other stations too.
IC1 = ATTiny85 with program from : http://meteo.annoyingdesigns.com/DavisSPI.pdf
C1 = 100n (optional)
D1 = 3v3 Zener (optional)
R1 = 470R (optional, short if not used)
J1 = 2x10 female header 2.0mm pitch
Should be used with USB-UART cable (tested with PL2303, should work with others too), B-ground, W-cable’s Tx, G-cable’s Rx. If cable is 5V one, it’s recomended to use R1 and D1 as a voltage clamping since Davis operates at 3v3.
Show full description