2 layer board of 2.24 x 2.00 inches (56.8 x 50.8 mm)
Uploaded:
September 05, 2015
Shared:
September 11, 2015
Total Price:
$22.35
This board enables me to use two 12V RGB LED light controllers (check out ebay) for manual control of up to 6 dew heater bands. However I can also switch any or all the channels over for automated control using the Arduino and a temperature / humidity sensor.
This board has two switch ICs that…
This board enables me to use two 12V RGB LED light controllers (check out ebay) for manual control of up to 6 dew heater bands. However I can also switch any or all the channels over for automated control using the Arduino and a temperature / humidity sensor.
This board has two switch ICs that switch over the control signal for each of the 6 channels between the manual Pot and the 6 channel digital Pot on this board.
If you add in 2mm JST connectors / cables and connec the connector from the manual Pots on the RGB dimmers, to this board (CH1_POT….) and then similar connects from this boards outputs (CH1_BO) back to the sockets on the RGB dimmer boards - then you have yourself a SPI controlled 6 Channel Dew Controller.
There are no passive components on the board, only power, ground, ICs and connectors. The power being used by the ICs is 5V.
Show full description
This board enables me to use two 12V RGB LED light controllers (check out ebay) for manual control of up to 6 dew heater bands. However I can also switch any or all the channels over for automated control using the Arduino and a temperature / humidity sensor.
This board has two switch ICs that…
This board enables me to use two 12V RGB LED light controllers (check out ebay) for manual control of up to 6 dew heater bands. However I can also switch any or all the channels over for automated control using the Arduino and a temperature / humidity sensor.
This board has two switch ICs that switch over the control signal for each of the 6 channels between the manual Pot and the 6 channel digital Pot on this board.
If you add in 2mm JST connectors / cables and connec the connector from the manual Pots on the RGB dimmers, to this board (CH1_POT….) and then similar connects from this boards outputs (CH1_BO) back to the sockets on the RGB dimmer boards - then you have yourself a SPI controlled 6 Channel Dew Controller.
There are no passive components on the board, only power, ground, ICs and connectors. The power being used by the ICs is 5V.
Show full description
