Schlage lock bottom pin gauge.

This helps measure bottom pins from a deadbolt after dumping them in a pinning tray while re-key lock. Slide the pin along interior gauge to see which pin number it is.

schlage deadbolt lock bottom pins and master pins gauge.

The top larger slot is for bottom pins, and the smaller recessed area is for master pins.

Useful for home or hobby locksmith and lock sport. I used this to rekey my schlage deadbolt. This gauge is handy to measure dumped pins from a lock and to help sort bottom and master pins.

This is only for Schlage lock pins and not kwikset lock pins.

AccuTemp

Accurate temperature measurement wemos d1 shield.

• Uses 4 high precision sensors from different manufacturers (STS3x, MCP9804, Si7051, MAX31889)
• Sensors arranged within 11x11 mm square, to share common heat sink (heat source).
• Wemos pins D1,D2 for SCL,SDA i2c.
• Pads available for sensor output, and wemos gpio (solder jumpers as needed)
• OLED 128x64 support with swapable Vcc/Gnd pins to handle different pin styles.

UPDATE:

This board has error with R2 and D3 pin which doesn’t fully go off on Wemos. Instead, I added a jumper wire to another pin (D4 I think).

Otherwise, just leave R2 disconnected and dont use that LED pin. Other data functions and OLED screen work well.