Shared Projects by mikoyv

Shared Projects by mikoyv

OpenFIRE (I2C) DIY Wiimote IR Camera PCB (JST PH 2.0)

2 layer board of 0.52 x 1.19 inches (13.1 x 30.2 mm)
Uploaded: November 02, 2026
Shared: November 02, 2026
Total Price: $3.05

-Beginner-Friendly Through-Hole Resistors: Uses through-hole resistors (4.7kΩ) for easy hand-soldering and a slim profile.

-Official Hardware Guide Aligned: The trace layout is designed directly from the “DIY Wiimote Conversion (Using Clock Pin)” schematic on page 4 of the official OpenFIRE-Hard…

Show full description

-Beginner-Friendly Through-Hole Resistors: Uses through-hole resistors (4.7kΩ) for easy hand-soldering and a slim profile.

-Official Hardware Guide Aligned: The trace layout is designed directly from the “DIY Wiimote Conversion (Using Clock Pin)” schematic on page 4 of the official OpenFIRE-Hard…

Show full description

Embeddable link to order this shared Project

openfire-resistor-capacitor-unofficial

2 layer board of 0.52 x 1.19 inches (13.1 x 30.2 mm)
Uploaded: November 02, 2026
Shared: November 02, 2026
Total Price: $3.05

Discussions from Discord suggested that adding a localized decoupling capacitor on the camera module's power rail is best practice to stabilize voltage delivery and minimize potential noise. There is an active documentation change request to update the official OpenFIRE schematic guidelines accor…

Show full description

Discussions from Discord suggested that adding a localized decoupling capacitor on the camera module's power rail is best practice to stabilize voltage delivery and minimize potential noise. There is an active documentation change request to update the official OpenFIRE schematic guidelines accor…

Show full description

Embeddable link to order this shared Project