Shared Projects by fossum

Shared Projects by fossum

Smart Fridge Pi Hat

2 layer board of 1.38 x 2.40 inches (35.0 x 61.0 mm)
Uploaded: February 29th 2020
Shared: March 23rd 2020
Total Price: $16.50

Smart Fridge Pi Hat

Tested working board, v1.0

For needed code, visit thefoss.net

BOM

Description Quantity
[Chip Resistor (805, 4.7k ohm)](https://www.digikey.com/product-detail/en/yag…

Show full description

Smart Fridge Pi Hat

Tested working board, v1.0

For needed code, visit thefoss.net

BOM

Description Quantity
[Chip Resistor (805, 4.7k ohm)](https://www.digikey.com/product-detail/en/yag…

Show full description

Embeddable link to order this shared Project

EMC1072 breakout

2 layer board of 0.49 x 0.55 inches (12.4 x 14.0 mm)
Uploaded: January 26th 2017
Shared: February 19th 2017
Total Price: $1.30

The EMC1072 dual temp IC, allows you to monitor two temp.s at once and communicates in I2C for ease of use. For a C++ library see http://thefoss.net/ericfoss/emc1072

The EMC1072 dual temp IC, allows you to monitor two temp.s at once and communicates in I2C for ease of use. For a C++ library see http://thefoss.net/ericfoss/emc1072

Embeddable link to order this shared Project

Bluetooth Radio Breakout

2 layer board of 1.53 x 1.33 inches (38.8 x 33.7 mm)
Uploaded: July 18th 2016
Shared: July 19th 2016
Total Price: $10.10

Embeddable link to order this shared Project

Headset Breakout

2 layer board of 0.59 x 0.63 inches (14.9 x 16.0 mm)
Uploaded: May 23rd 2016
Shared: June 2nd 2016
Total Price: $1.85

Breakout board for a full featured 2.5mm TRRS headset. You don't need all the pins, but they are there just in case.

I made this with a SJ1-4253x from Digikey. You may need to clip the guide posts on the bottom of the part, but other than that it fits fine.

Breakout board for a full featured 2.5mm TRRS headset. You don't need all the pins, but they are there just in case.

I made this with a SJ1-4253x from Digikey. You may need to clip the guide posts on the bottom of the part, but other than that it fits fine.

Embeddable link to order this shared Project

Hall-effect Breakout

2 layer board of 0.34 x 0.45 inches (8.7 x 11.4 mm)
Uploaded: December 15th 2015
Shared: May 14th 2016
Total Price: $0.75

This is my breakout board for testing/using any US1881 style hall-effect IC.

Solder jumpers to anything 0.1" spacing and the hall goes in the other holes. Resistors go on the SMD pads.

This is my breakout board for testing/using any US1881 style hall-effect IC.

Solder jumpers to anything 0.1" spacing and the hall goes in the other holes. Resistors go on the SMD pads.

Embeddable link to order this shared Project