Shared Projects by floep

Small breakout board with SWD headers for the EByte NRF52832 Module. All pins are accessible.

A Small STM32F103C8T6 board with all functional pins exposed. Similar to the BluePill board except:

• no regulator. Will be powered by 2 AA batteries.
• no USB
• No LED
• No BOOT0/BOOT1 jumper pins. BOOT0 can be pulled high by a button, BOOT1 is pulled low permanently but exposed by a PIN.
• smaller crystals
• RFM69CW + RFM69(H)W + RFM69HCW footprints + u.FL connector
• VBAT can be disconnected from VCC by cutting the solder jumper on the back.

Parts can be sourced from aliexpress.

The size is 36.56mm x 20.32mm (1.4" x 0.8"). 5 mils trace width and clearance. 20 mils edge clearance.

Tested succesfully V3 with jlcpcb order.
Test failed with V3.4 pcbs.io order due to imposed edge clearance. Should be corrected as of V4.3.
V5 was net yet tested.

github repo: https://github.com/freynder/STM32_Sensor

Top view

Bottom view

Pinout diagram (draft)

BOM

BOM

Version history

• V1: was never released because it was faulty and had less pins exposed.
• V2: had full pin availability but the layout was messy.
• V3: is V2 + u.FL connector + better layout and clearer markings.
• V3.3: corrected mislabeling + moved board edges to fit on breadboard (only sides).
• V3.4: moved labels so they are still visible when headers are soldered on. Optimized a few traces. Changed custom button footprint to RS282G05A3 buttons.
• as of V4 detailed history is tracked in git log.
• V5: Added RFM69(H)W footprints. Cleaned up git. Cleaned up tracks, fab layer, silk screen.

A small RFM69C shield for easy mounting on an STM32 BluePill board.