PWM/TTL Laser Driver 0-4A Adjustable
2 layer board of 2.23 x 1.52 inches (56.6 x 38.6 mm)
Uploaded:
February 11, 2017
Shared:
February 13, 2017
Total Price:
$16.90
Bill of materials is as follows:
C1,C4 1u, C2 22u 25V, C3 4.7u, C5 0.1u, D2 0805 LED GREEN, L1 3.3uH (Bourns SRP6540-3R3M), R1 R020 (20mR), R2 4K7, R3 R020 (20mR), R4 10K, R5 20K, R6 100R, R7 220R, RV1 1K, U1 LED2001PHR, U2 LM4040, U4 4N25.
VIN and LASER output connectors are JST VH (3.96mm…
Show full description
Bill of materials is as follows:
C1,C4 1u, C2 22u 25V, C3 4.7u, C5 0.1u, D2 0805 LED GREEN, L1 3.3uH (Bourns SRP6540-3R3M), R1 R020 (20mR), R2 4K7, R3 R020 (20mR), R4 10K, R5 20K, R6 100R, R7 220R, RV1 1K, U1 LED2001PHR, U2 LM4040, U4 4N25.
VIN and LASER output connectors are JST VH (3.96mm…
Show full description
ControLeo2 compatible reflow oven controller rev C
2 layer board of 4.27 x 2.19 inches (108.6 x 55.7 mm)
Uploaded:
March 13, 2016
Shared:
March 13, 2016
Total Price:
$46.85
ControLeo2 compatible reflow oven controller based on Brian Barrett’s design - http://goo.gl/sMXg10. The schematic, gerbers and BOM for this design are downloadable from here - https://goo.gl/gqWeKn.
ControLeo2 compatible reflow oven controller based on Brian Barrett’s design - http://goo.gl/sMXg10. The schematic, gerbers and BOM for this design are downloadable from here - https://goo.gl/gqWeKn.
ST1C440 constant current laser driver
2 layer board of 1.30 x 1.42 inches (33.1 x 36.2 mm)
Uploaded:
January 31, 2016
Shared:
February 05, 2016
Total Price:
$9.25
ST1C440 constant current laser driver with opto isolated MCU control.
ST1C440 constant current laser driver with opto isolated MCU control.
A4988 stepper board
2 layer board of 2.11 x 3.38 inches (53.5 x 85.9 mm)
Uploaded:
January 30, 2016
Shared:
January 31, 2016
Total Price:
$35.60
A4988 stepper motor driver board. This board allows the use of two motors for driving the X-axis via two jumpers or use three separate motors for three axes.
A4988 stepper motor driver board. This board allows the use of two motors for driving the X-axis via two jumpers or use three separate motors for three axes.
