Shared Projects by davetheresurrector

Shared Projects by davetheresurrector

Remex_RRS3300_Speed_Limit.kicad_pcb

2 layer board of 1.31 x 1.30 inches (33.2 x 33.1 mm)
Uploaded: August 23, 2024
Shared: August 23, 2024
Total Price: $8.50

The RRS3300 paper tape reader rewinds dangerously fast, slow it down using a sprocket hole tachometer. Can use virtually any 8-pin PIC uC but I will write the program for PIC16F18015. Applies only to instruments built with phase-control triac Soft Start board.

The RRS3300 paper tape reader rewinds dangerously fast, slow it down using a sprocket hole tachometer. Can use virtually any 8-pin PIC uC but I will write the program for PIC16F18015. Applies only to instruments built with phase-control triac Soft Start board.

Embeddable link to order this shared Project

Fluke 8060 Low Frequency Beep.kicad_pcb

2 layer board of 0.99 x 0.62 inches (25.2 x 15.8 mm)
Uploaded: April 04, 2024
Shared: April 18, 2024
Total Price: $3.05

The Fluke 8060A handheld DMM's continuity test beep is about 2700 Hz and I can't hear it. This board plus firmware (PIC10F320-IOT or 322-IOT) shifts it to a lower frequency. Other parts are 2N7002, 470R 0805 and 1uF 1206. Cut off the ICSP header after programming.

The Fluke 8060A handheld DMM's continuity test beep is about 2700 Hz and I can't hear it. This board plus firmware (PIC10F320-IOT or 322-IOT) shifts it to a lower frequency. Other parts are 2N7002, 470R 0805 and 1uF 1206. Cut off the ICSP header after programming.

Embeddable link to order this shared Project

HP-Chopper-Photocell-Driver.kicad_pcb

2 layer board of 2.62 x 1.18 inches (66.6 x 30.0 mm)
Uploaded: August 24, 2022
Shared: November 19, 2023
Total Price: $15.45

HP 740B Chopper Photocell Driver board version 1.2, supersedes v1.0 . Increased creepage distance, EMI-hardened, and connectors up high to work in A16 position. (Fine for A17 too of course). Probably works in 741B and 419A.

V1.0 description: Rejuvenate tired photochopper modules in vintage Hew…

Show full description

HP 740B Chopper Photocell Driver board version 1.2, supersedes v1.0 . Increased creepage distance, EMI-hardened, and connectors up high to work in A16 position. (Fine for A17 too of course). Probably works in 741B and 419A.

V1.0 description: Rejuvenate tired photochopper modules in vintage Hew…

Show full description

Embeddable link to order this shared Project