i2c-duino-power-source.zip
2 layer board of 2.15 x 0.73 inches (54.5 x 18.6 mm)
Uploaded:
July 16th 2017
Shared:
October 1st 2017
Total Price:
$7.85
A 5 Volt power source for the i2c-duino. With a heat sink in the 7805 this can deliver up to 1.5 Amp and can power 3 i2c-duinos
A 5 Volt power source for the i2c-duino. With a heat sink in the 7805 this can deliver up to 1.5 Amp and can power 3 i2c-duinos
i2c-duino.zip
2 layer board of 2.93 x 0.73 inches (74.5 x 18.6 mm)
Uploaded:
July 16th 2017
Shared:
October 1st 2017
Total Price:
$10.70
This board creates an i2c bus with an ATMega 328 processor. It can be used as an i2c master or slave. Great to use with Raspberry to add A/D ports to the Ras…
This board creates an i2c bus with an ATMega 328 processor. It can be used as an i2c master or slave. Great to use with Raspberry to add A/D ports to the Ras…
miniDuino-np.zip
2 layer board of 2.05 x 0.71 inches (52.0 x 18.0 mm)
Uploaded:
July 2nd 2017
Shared:
October 1st 2017
Total Price:
$7.25
This is the same ATMega-328 breakout sans power source. Very useful when used for prototyping on a breadboard where the power supply is already supplied.
This is the same ATMega-328 breakout sans power source. Very useful when used for prototyping on a breadboard where the power supply is already supplied.
miniDuino.zip
2 layer board of 2.95 x 0.79 inches (75.0 x 20.0 mm)
Uploaded:
April 11th 2017
Shared:
October 1st 2017
Total Price:
$11.60
miniDuino
This board is a full fledged ATMEL-328-20p break out with FTDI connector. It is 100% compatible with Arduino and can be programed using the Ardu…
miniDuino
This board is a full fledged ATMEL-328-20p break out with FTDI connector. It is 100% compatible with Arduino and can be programed using the Ardu…
GlowSaber
2 layer board of 0.93 x 4.14 inches (23.5 x 105.0 mm)
Uploaded:
June 11th 2015
Shared:
October 1st 2016
Total Price:
$19.10
This is the main PCB for my GlowSaber project. A detailed step by step instructions to build the GlowSaber can be found in the site [GlowSaber Physics](http:…
This is the main PCB for my GlowSaber project. A detailed step by step instructions to build the GlowSaber can be found in the site [GlowSaber Physics](http:…