Shared projects

Tinusaur Board v0.2 RC1

By boyanov

2 layer board of 0.90 x 1.40 inches (23.0 x 35.7 mm).
Shared on February 8th, 2014 14:15


Tinusaur Board v0.2 RC1

By boyanov

2 layer board of 0.90 x 1.40 inches (23.0 x 35.7 mm).
Shared on February 8th, 2014 14:15

The Tinusaur - a minimal micro-controller hardware configuration based on Atmel AVR ATtiny family of products and more specifically those with DIP-8 case such as ATtiny25/ATtiny45/ATtiny85, ATtiny13 as well as their variations.

Circuit is available at 123d.circuits.io

The home of the Tinusaur is at this address: tinusaur.wordpress.com



Tinusaur Board v0.1 m2

2 layer board of 0.90 x 1.40 inches (23.0 x 35.7 mm).
Shared on December 8th, 2013 21:13


Tinusaur Board v0.1 m2

2 layer board of 0.90 x 1.40 inches (23.0 x 35.7 mm).
Shared on December 8th, 2013 21:13

The Tinusaur - a minimal micro-controller hardware configuration based on Atmel AVR ATtiny family of products and more specifically those with DIP-8 case such as ATtiny25/ATtiny45/ATtiny85, ATtiny13 as well as their variations.

Circuit is available at 123d.circuits.io

The home of the Tinusaur is at this address: http://tinusaur.wordpress.com



Tiny Header Board 1.2 m2

By boyanov

2 layer board of 0.90 x 1.40 inches (23.0 x 35.7 mm).
Shared on November 1st, 2013 11:17


Tiny Header Board 1.2 m2

By boyanov

2 layer board of 0.90 x 1.40 inches (23.0 x 35.7 mm).
Shared on November 1st, 2013 11:17

Tiny header board for the Atmel AVR ATtiny chips in DIP-8 such as ATtiny 25/45/85 (ATtiny13 as well)

The goal is to have a board that you can start using right a way, contains the minimum required components to run properly and will even let you prototype simple projects without using a breadboard.

Circuit is available at 123d.circuits.io



Tiny Header Board 1.2 m1

2 layer board of 0.90 x 1.20 inches (23.0 x 30.6 mm).
Shared on September 25th, 2013 11:52


Tiny Header Board 1.2 m1

2 layer board of 0.90 x 1.20 inches (23.0 x 30.6 mm).
Shared on September 25th, 2013 11:52

Tiny header board for the Atmel AVR ATTiny chips in DIP-8 such as ATTiny 25/45/85.

The goal is to have a board that you can start using right a way, contains the minimum required components to run properly and will even let you prototype simple projects without using a breadboard.

Circuit located at 123d.circuits.io