Shared Projects by VeteranGamer

This board has been designed and created by Helder (from the Sudomod Forum)

ideally suited to be paired with his RetroPSU allowing a Power ON button, along with the addition of a Safe Shutdown function that completely kills the Power to the build/project

Parts required are:

Dual Fet is : SI4532CDY-T1-GE3 P-Channel Fet: SI2301CDS-T1-GE3 D1: MBR0520LT1G

R3: 10K R6: 100K R7: 300K R8: 100K R9: 300K

C3: 1uf C4: 0.1uf C5: 10uf C6: 10uf

add this to the Config.txt dtoverlay=gpio-poweroff:gpiopin=“14”,active_low=“y”

and addition script like the MintyBatteryMonitor will also need to be enabled to allow for the Safe Shutdown

.

this is a work in progress….

and is NOT the finished article….

you can contact me on Sudomod.com/forum fof more info

this board is to be used in conjunction with my other board (ili9341 18Pin LCD Connector Board)

once soldered to the Raspberry Pi the two boards are connected via a 8pin 1.0mm pitch ribbon cable (connectors & ribbon cable will be required)

this is to be used with this script to achieve 60FPS https://sudomod.com/forum/viewtopic.php?f=22&p=60767#p60767

.

This board is to be used with any 18Pin ili9341 TFT LCD for connection to any Raspberry Pi (Zero/2/3)

GBZ builds… its design to work best when your Micro SD card is positioned to be accessed via the contrast opening on the DMG shell

the screen can be soldered directly to the board or a 18pin 0.8mm pitch ribbon connector can also be used.

this board is to be used in conjunction with my other board (ili9341 Raspberry Pi Connector) that soldered to the Raspberry Pi and connects these two boards via a 8pin 1.0mm pitch ribbon cable (connectors & ribbon cable will be required)

a 0805 10R resistor is also need, but this can be changed to which ever value suits you based on the desired brightness you require

.

his board is to be used in conjunction with my other board (ili9341 18Pin LCD Connector Board)

once soldered to the Raspberry Pi the two boards are connected via a 8pin 1.0mm pitch ribbon cable (connectors & ribbon cable will be required)

(Reversed Version) to be used with a reversed ribbon cable

.