Shared Projects by Silinary

Breakout for WSON-6. Pads for capacitors between GND and VIN, as well as GND and +Vout. Originally developed for LP3869x. Breakout pins: VIN - Top Left GND - Bottom Left Vout - Top Right Enable - bottom Right

1uF capacitors were used per the datasheet.

For the regulator: https://www.digikey.com/products/en/integrated-circuits-ics/pmic-voltage-regulators-linear/699?k=&pkeyword=&v=296&pv1989=0&pv1291=2272&FV=ffe002bb&mnonly=0&ColumnSort=0&page=1&stock=1&datasheet=1&quantity=0&ptm=0&fid=0&pageSize=500

efm8 24pin breakout. 16pin breakout.

2* power stabilizing capacitors on top - 1uf and .1uf according to the datasheet.

1* 10k pullup resistor on the underside (optional). If putting pins on the pcb, this underside resistor can be included. If surface mounting the pcb, this can be left out if adding the pullup elsewhere in the circuit.

1* EFM8SB2-24 module. 4x4 QFN module.

Pin assignments on both sides if needed. Only 16 pins broke out. VCC, GND, C2D, C2CK, and the rest are for ports

Resistor and Capacitor footprint for 1206 size.

Size is an attempt to keep the module a standard size of 4 breadboard pins to be able to fit down the middle.