Shared Projects by PhillyFlyers

Graupner MZ-32 DSM/DSMX Adapter (with optional JR module header)

T962A Controller using 5.0" 800x480 Capacitive-Touch TFT Display (or an optional 7.0" 800x480 display with simple change)

DROP-IN replacement board for T962/T962A oven. Uses STM32H7 microcontroller.

T962A Controller

DROP-IN replacement board for T962/T962A oven. Uses PIC32MZEFH microcontroller.

(small T962 ovens will need to add an SSR-25 solid state relay to control heater elements, just like T962A does, as on board AC control of heaters is a very BAD idea; they need to use an SSR control for safety.)

* FYI: Updated the board to have tented vias, and added silkscreen borders for SMD component placement

Homebrew DSOX Lan card for the DSOX 2k & 3k series scopes, using the current homebrew LAN board designs, but with added on functionality for USB-UART and full JTAG buffer, to utilize the internal RS232 and JTAG connectors on the scope main board.

This allows you to have 3-in-1 functionality from the same board: 1) LAN 2) USB-UART 3) JTAG buffer

The USB-UART gives a simple USB-B connector on the faceplace, which provides full acess to the RS232 connector on the scope main board. This is powered by an MCP2221 chip, which gets power from the host USB interface, so that you can have the serial port ready and open before the scope is even powered on. necessary in order to halt UBOOT at immediate scope power-on

JTAG 10-pin male IDC connector for full JTAG functionality, which is connected from 10-pin header to the main board jtag header via IDC cable.

Faceplace for the DSOXLan_Plus board…

just use the raw copper on the back to tack solder it at a 90 degree to the board…