Water_Detecterer_Board.kicad_pcb
2 layer board of 3.51 x 1.31 inches (89.2 x 33.2 mm)
Uploaded:
March 23, 2021
Shared:
July 02, 2022
Total Price:
$22.90
Water sensor board. Deploy these boards to detect when your aquarium water swam out of the tank and onto the floor. (requires auxiliary circuitry) Use double sided tape with the wax paper still on one side to set the board off the floor.
Water sensor board. Deploy these boards to detect when your aquarium water swam out of the tank and onto the floor. (requires auxiliary circuitry) Use double sided tape with the wax paper still on one side to set the board off the floor.
Edge_Connector_Andrews_1
2 layer board of 2.59 x 0.70 inches (65.8 x 17.8 mm)
Uploaded:
June 23, 2020
Shared:
June 23, 2020
Total Price:
$9.05
A board for interfacing a bare chip or wafer dice with a card edge connector.
A board for interfacing a bare chip or wafer dice with a card edge connector.
Split Supply Power Distribution Board V2
2 layer board of 3.29 x 1.35 inches (83.5 x 34.3 mm)
Uploaded:
March 30, 2016
Shared:
March 27, 2017
Total Price:
$22.15
***NOTE: You can put the capacitors on the bottom side of the board to give easier access to the 3-pin connectors.
***NOTE: You can put the capacitors on the bottom side of the board to give easier access to the 3-pin connectors.
SG3525 Breakout V1
2 layer board of 2.59 x 1.23 inches (65.7 x 31.1 mm)
Uploaded:
September 20, 2014
Shared:
October 18, 2014
Total Price:
$15.85
PWM controller for…anything. MOSFET pads not included. This circuit can be used for driving a flyback transformer or making electronic noises. Connect the labeled outputs to a pair of MOSFETS if you want to drive a flyback or connect one of the outputs directly to an amplified speaker if you…
Show full description
PWM controller for…anything. MOSFET pads not included. This circuit can be used for driving a flyback transformer or making electronic noises. Connect the labeled outputs to a pair of MOSFETS if you want to drive a flyback or connect one of the outputs directly to an amplified speaker if you…
Show full description
555 Pocket Theremin
2 layer board of 2.59 x 1.25 inches (65.7 x 31.8 mm)
Uploaded:
September 11, 2014
Shared:
October 18, 2014
Total Price:
$16.15
This is the first version of a board based on a "Pocket Theremin" published in a Popular Science article. I've tested the board and it is functional. You will need to attach two variable resistors in the indicated locations. The variable resistors can be anything–playdough, photoresistors, sa…
Show full description
This is the first version of a board based on a "Pocket Theremin" published in a Popular Science article. I've tested the board and it is functional. You will need to attach two variable resistors in the indicated locations. The variable resistors can be anything–playdough, photoresistors, sa…
Show full description
