Shared Projects by Clyde

This is an adapter board for the STLINK-V3PWR programmer to break out the 1.27 mm pin pitch to standard 0.025 inch square pins on 0.1 inch centers. You will need a cable from Samtec like their FFSD-07-D-06.00-01-N.

Here is a link to the design files and the BOM and assembly drawings.

https://github.com/clydeshappee/74XX-Defined-Radio/tree/main

Audio shield with line and mic inputs. This is for the Digilent Arty or an Arduino.

Documentation is here:

https://github.com/clydeshappee/ArtyAudio

[email protected]

Temperature and voltage PMOD interface for Digilent Zybo Z7.

This is a board for the Digilent Arty A7-35 to provide 8 digits of 7 segment display. There is also an R2R D/A converter chip to play with. The zip file has a PDF schematic with the part numbers on it and there is also a folder with Verilog HDL to drive the displays.

The displays are multiplexed and control is included in the logic to light up the decimal point, or points. The decimals may be in any arbitrary pattern. There is also logic to blank leading zeros. The blanking may be turned on or off at will.

The test harness is included. I have not seen my board work, but the logic has been simulated to where I think it is correct. Also included is a constraint file. This board may work with other Digilent boards, but I only have my A7-35 in mind.

Update 2018-06-12. Contact me for an update to the Verilog HDL. [email protected]