Shared Projects by Bri-Bri

This board is designed for constructing 14, 16, 18, and 20-pin DIP IC circuits. The “equals” signs (=) indicate holes connected together on the top side of board; the enclosed square is most commonly used as a common ground bus. . Ordering in the “After Dark” option is best, since the clear solder mask will make bottom side traces much more visible. The two mounting holes accept either M2 or #2-56 screws. Obviously there is no Bill of Materials or documentation needed, so no links are listed.

This little board is suitable for constructing most circuits which utilize a single 8-pin DIP IC, including single and dual op-amps, 555 timers, and 386 audio amplifiers–among many others. The “equals” (=) signs on the silkscreen indicate holes which are connected together; the outer enclosed square is used as a common ground bus. It is best to order this board in the “After Dark” option, since the clear solder mask will make copper traces much more easy to see on the bottom side. The two mounting holes accept either M2 or #2-56 screws. Obviously there is no Bill of Materials or documentation with this project, so no links are listed.