Electronic clock switch for 1Chip-SNES, SNES Mini and Jr.

By borti4938

2 layer board of 1.15 x 1.04 inches (29.2 x 26.5 mm).
Shared on January 7th, 2015 19:04


Electronic clock switch for 1Chip-SNES, SNES Mini and Jr.

By borti4938

2 layer board of 1.15 x 1.04 inches (29.2 x 26.5 mm).
Shared on January 7th, 2015 19:04

Solder Joints:
1 - mode (in) Vcc = PAL-mode, GND = NTSC-mode, same as at S-CPUN pin111
2 - inverted mode (out) to be jointed to lifted pin9 of S-RGB IC
3 - clock (out) to be jointed S-CPUN pin9 (either remove X1 or lift pin9 on S-CPUN)


Values of passive components (all 0805 packages except crystals):
R1, R2: 330Ohm
R3, R4: 1MOhm
C1, C2: 0.1uF
C3 - C6: 22pF (exact value: C3=C4=C5=C6= 2*(CL-CS), where CL is load cap. and CS is stray cap. of 74HCU04)
X50: 17.734MHz
X60: 21.477MHz


Active ICs (SOIC14 packages):
74*00: four 2-NAND gates, use 7400, 74LS00, 74HC00, and so on
74HCU04: six inverter, using unbuffered inverter as displayed performs best